Banks-power GM Motorhomes: (Gas ’82 - 95 7.4L) PowerPack syste Manual de usuario

CHEVROLET/GM 454 CLASS-A MOTORHOMEP-30 CHASSIS WITH FUEL INJECTIONTHIS MANUAL IS FOR USE WITH SYSTEM PART NUMBER 49069GALE BANKS ENGINEERING546 DUGGAN

10P.N. 96354Raise front of vehicle on hoist or ramps. Note: Figure 9 shows how ramps may be construct-ed for this purpose.WARNING! Observe safety prec

On vehicles with a conventional full-size startermotor, install new starter heat shield, supplied asdescribed in steps 18 and 19. Remove factory heat

12P.N. 96354Remove the shield and spread it open enough so it can beslid onto the new Banks Dynaflow™ Muffler. Attach shieldwith two No. 136 hose clam

variety of coach body configurations, and therefore differ-ent vehicle weights, some experimentation will most likelyhave to be done to obtain the des

14P.N. 96354CLEANING AND OILING THE BANKS RAM-AIR FILTERPRE-CLEANINGTap the element to dislodgeany large embedded dirt, thengently brush with a soft b

8 MUFFLER, Dynaflow, Stainless Steel, 21⁄2 x3" 5240416 PIPE, Chrome Tailpipe Tip 52285CARD, Product Registration96392DECAL, Carb E.O.-D-161-32960

This page intentionally left blank.

2P.N. 96354This page intentionally left blank.

BANKS POWERPACK®SYSTEMGM 454 MOTORHOMESP-30 CHASSIS with FUEL INJECTIONDear Customer,Your new Banks PowerPack is a unique combination of air intake, e

4P.N. 96354GENERAL ASSEMLBYSEE PAGE 15 FOR PARTS LISTINGFIGURE 1

5P.N. 96354GENERAL INSTALLATION PRACTICESFor ease of installation and trouble-free operation ofyour Banks PowerPack, PLEASE READ THIS 15-PAGEOWNER‘S M

6P.N. 96354INSTALLATION PROCEDUREThe Banks Ram-Air cold air induction components are designedto extend the factory air intake path so that cooler outs

Drill four 3⁄16" diameter holes through the air inlet hoodbracket around the perimeter of the center hole. SeeFigure 5. If the bracket cannot be

8P.N. 96354Figure 6Figure 5

9P.N. 96354Figure 7Figure 8CABLE TIE MOUNTINGSTRAP MOUNTINGRAM-AIR SUPER-SCOOP MOUNTING METHODS